Pressing DTF transfers correctly is the key to vibrant, durable prints that survive real wash cycles. Follow this proven hot-peel workflow for consistent results on cotton, blends, and polyester.
Recommended settings
- Temperature: 300–320°F (150–160°C)
- Time: 10–15 seconds
- Pressure: Medium to firm
- Peel: Hot peel
Step-by-step
- Pre-press the garment for 3–5 seconds to remove moisture and wrinkles.
- Position the transfer film-side up on the garment.
- Press at 300–320°F for 10–15 seconds with medium-firm pressure.
- Hot peel the film smoothly right after pressing — do not let it cool.
- Repress for about 5 seconds with a finishing sheet or parchment to lock in durability and soften the hand feel.
Tips for best results
- Use even pressure across the whole platen — uneven pressure causes lifting.
- If edges lift, increase time slightly or check your pressure.
- Wait 24 hours before the first wash for maximum adhesion.
- Wash inside out in cold water and avoid harsh dryers for longest life.
Different presses run hot or cold, so verify your platen temperature with an infrared thermometer if results look inconsistent.
Order a RavenDTF sample pack to dial in your press settings before running a full job.